Scribers, Pin Vises & Pick Sets

Machinist' Scribe Hooks & Picks, 8 in, Tempered Steel, Nickel-PlatedFeaturesThis machinist scribe is made of tough aluminum to provide maximum resilience in difficult situationsThis tool features a tempered steel and nickel plated tip for easily use and...

Awls, 0.307 in Shank Diam, 4 15/16 in Shank Length, Tool SteelFeaturesQuality design and construction give Apex® awls a long service life and durabilityWith Apex® hand drivers you are assured of high quality and industrial strength. Apex® awls are...

8-Pc Hook and Pick Set, High Carbon Steel, Rubber Handles, 9-3/4 in L, Nylon PouchFeaturesConstructed of high polished heat-treated carbon steelIdeal for separating wires, removing fuses, O-rings, retrieving washers, and other loose partsStandard...

SCRATCH AWLFeaturesHeat-treated shaftOne-piece forged-steel blade

Cushion-Grip Scratch Awl, 3-1/2 inFeaturesHandle resists slippageHeat-treated and tempered shankDeep ribbed designHard pointHandle resists oil, gas, and water

Pin Vises, 0.11 in - 0.187 in Pin Range, 9/16 in Dia.FeaturesFor holding small rods, wire, drills, taps and other small toolsTool steel collets at each end are hardened and grip firmly when screw chuck is tightenedNickel plated body is hollow to permit...

Improved Scriber, 9 in, Steel, Straight Point; Short Bent PointFeaturesSteel, properly tempered and well finishedPoints are finely taperedHandle, as well as the points, have a knurled gripSeveral points are furnishedLong bent point is handy for reaching...

41068 PIN VISEFeatures

162B PIN VISE .030-.062"FeaturesJaws on all are hardened and with a few turns of the binding nut, a firm grip may be obtainedHandles and binding nuts are nickel-platedHole extends through the full length of the handles so that wires of any length and any...

Replaceable Needlepoint Scribers, 5 5/16 in, Hardened Steel, Straight PointFeaturesNork pattern scriberFour extra points stored under cap

240B PIN VISE W/TAPEREDFeaturesSpecial collet design with tapers at both ends, providing maximum clamping surfaceHave a smaller body diameter than the chuck, which allows fast opening/closing and rapid rotation between the thumb and finger when used on...

Replacement Tips for Scriber/Etching Pens, Used for #88 and #89, Tungsten CarbideFeaturesThe tip is made of high quality tungsten carbideDurable engraved tip works effortlessly on hardened and stainless steel, ceramic and glass

Pocket Scribers, 4 15/16 in, Hardened Steel, Straight PointFeaturesReplaceable hardened centerless ground pointPoint reverses into knurled body for safety

Double Pointed Scriber, 9-1/2 in, Carbon Steel, Straight/Bent PointFeaturesConstructed of bright polished high carbon steelFor the technician or craftsman who needs a sharp marking tool that works in cramped quarters as well as in regular applicationsOne...

Pin Vises, 0.025 in - 0.075 in Pin Range, 3/8 in Dia.FeaturesFor holding small rods, wire, drills, taps and other small toolsTool steel collets at each end are hardened and grip firmly when screw chuck is tightenedNickel plated body is hollow to permit...

4-Way Pick Set, 5 Pc, Aluminum HandleFeaturesPerfect for removing O-rings, scribing, pulling cotter pins, keys and springsMade in USA