PERLE SYSTEMS 06005274 Perle Gigabit Ethernet PoE+ Ethernet Extender eXP-4S1110PE-RJ - Network extender - GigE, Ethernet over VDSL2 - 10Base-T, 100Base-TX, 1000Base-T - 4 ports - up to 328 ft

Transparent to IP Video compression protocols. Fully transparent to such IP video compression schemes such as MPEG-4, H.264 and MJPEG. Fixed speed and duplex. Some Ethernet equipment require a fixed speed and duplex be used or cannot auto-negotiate. By disabling Auto-Negotiation on the Ethernet Extender, a fixed speed of 10 or 100 Mbps as well as Full or half Duplex can be configured through DIP switches. Plug and Play operation. Perle Ethernet Extenders will automatically configure your VDSL interlink connection. The CO/CPE peer association will be determined automatically by the Ethernet Extender. No need to set CO/CPE VDSL pairing. Once a connection is made, both ends will automatically adjust relevant VDSL parameters to optimize the level of bandwidth possible across the copper link. Loopback. When enabled, will perform a loopback on the copper VDSL interlink. Auto-negotiation. The Ethernet Extender supports auto negotiation on the 10/100/1000Base-T interface. Hi-speed performance. Utilizes second generation VDSL2 technology (ITU-T Recommendation G.993). When operating under "Profile 30a", Perle Ethernet Extenders can provide an aggregate VDSL line rate capability of up to 200 Mbps. Auto-MDIX. Auto-MDIX (Automatic Medium-Dependent Interface crossover) detects the signaling on the 10/100/1000 Ethernet RJ45 interface and determines the type of cable connected (straight-through or crossover) and automatically adopts a compatible pin-out. Power strain relief strap. A strain relief strap is provided to ensure a solid and secure power connection to the Ethernet Extender. Ideal for areas that may be exposed to vibration. Interlink fault feedback. Similar to the link pass-through feature, a loss of VDSL link will drop the 10/100/1000 Ethernet port on each end until the link recovers.