Laps & Hones

Soft Lathe Chuck Jaw: Serrated 1-1/2" OAW, 3" OAH, 3-3/4" OAL, 1" Between Mount Holes, Steel

1-1/4", Series QCFC65, QCFC Specialty System Collet 1-1/4" Collet Capacity, 0.0004" TIR

1-13/16", Series QCFC65, QCFC Specialty System Collet 1-13/16" Collet Capacity, 0.0004" TIR

Hard Lathe Chuck Jaw: 15'' Max Chuck Dia, Hard 3 Step, Case Hardened Steel

Soft Lathe Chuck Jaw: Tongue & Groove 2" OAH, Aluminum

Lathe Chuck Accessories; Accessory Type: T-Nut ; Product Compatibility: N-15; N-18 ; Chuck Diameter Compatibility (Decimal Inch): 18.0000

Soft Lathe Chuck Jaw: Serrated 18" OAW, 3" OAH, 1.9685" Between Mount Holes, 0.7874" Fastener, Cast Aluminum

Lathe Chuck Adapter Back Plate: 10" Chuck, for 1-105-1001, 1-201-1001 & 1-203-1001 Chucks Slotted Table, Slotted Table Mount, 9.843" OD, 3.189" Through-Hole Dia, 0.807" Flange Height, Steel

Soft Lathe Chuck Jaw: Serrated 10" OAW, 4" OAH, 5" OAL, 1.181" Between Mount Holes, Aluminum

Soft Lathe Chuck Jaw: Serrated 8" OAW, 2" OAH, 1.1811" Between Mount Holes, 0.3937" Fastener, Aluminum

Soft Lathe Chuck Jaw: Tongue & Groove 1" OAW, 2.03" OAH, Steel

Soft Lathe Chuck Jaw: Serrated 1-1/2" OAW, 2" OAH, 4-1/2" OAL, 1.1811" Between Mount Holes, 0.4724" Fastener, Aluminum

Manual Lathe Chuck: 3 Jaws, 5" Dia, Self-Centering Two-Piece Jaws, Plain Back Mount, 3,200 Max RPM

Soft Lathe Chuck Jaw: Tongue & Groove 18" OAW, 4" OAH, 3" Between Mount Holes, 0.875" Fastener, Cast Aluminum

Lathe Chuck Adapter Back Plate: 12" Chuck, for 1-105-1200, 1-106-1200, 1-107-1200, 1-201-1200, 1-202-1200, 1-203-1200 & 1-205-1200 Chucks Series L, L1 Mount, 12.4" OD, 3.35" Through-Hole Dia, Steel

5MT Mount, 0.86 to 1.85" Clamping Diam, Centered Pin Face Driver 3.39" Clamping Length, Spring Set, 1.18 to 2.44" Turning Diam, Mechanical Face Driver Actuation