ARMORED TEXTILES N55H15F100N FOREST LITE SINGLE JACKET FIRE HOSE 1-1/2"" X 100 FT 300 PSI WHITE FOREST LITE IS A SINGLE JACKET POLYURETHANE-LINED LIGHTWEIGHT HOSE INTENDED FOR USE IN WILD LAND FIRE SUPPRESSION. IT MEETS OR EXCEEDS NFPA 1961 FIRE HOSE STANDARD 2013 EDITION. DIAMETERS FOREST LITE IS AVAILABLE IN 1"" AND 1.5"" DIAMETERS. JACKET CONSTRUCTION THE JACKET IS VIRGIN SPUN HIGH TENACITY POLYESTER. THE OUTER JACKET IS THOROUGHLY IMPREGNATED WITH A POLYMER COMPOUND TO PROVIDE SUPERIOR RESISTANCE TO CHEMICALS ABRASION AND ULTRAVIOLET LIGHT. COMPOUND IS HEAT SET AT 250° F. LINING THE THERMOPLASTIC LINING SHALL BE A SINGLE-PLY EXTRUDED TUBE AND SHALL BE UNAFFECTED BY OZONE. THE FINISHED FORM SHALL BE FREE OF PITS OR OTHER IMPERFECTIONS AND SHALL HAVE A SMOOTH FINISH. NO RECLAIMED MATERIAL SHALL BE USED. THE TENSILE STRENGTH OF THE LINER SHALL NOT BE LESS THAN 2000 PSI WITH AN MAXIMUM ELONGATION OF 10 PERCENT. ADHESION THE ADHESION BETWEEN THE LINER AND THE INSIDE JACKET IS SUCH THAT THE RATE OF SEPARATION OF A 1.5"" WIDE STRIP CUT TRANSVERSELY SHALL NOT BE GREATER THAN 1"" PER MINUTE OVER A PERIOD OF TEN MINUTES UNDER A WEIGHT OF 12 POUNDS. ACCELERATED AGING LINING SPECIMENS SUBJECTED TO AN EXPOSURE OF 158° F +/- 3.6° F FOR A DURATION OF 96 HOURS SHALL BE CONDITIONED TO ASTM D 573 STANDARD TEST METHOD FOR RUBBER - DETERIORATION IN AN AIR OVEN. THEN THE SPECIMENS SHALL BE TESTED TO ASTM D4112 STANDARD TEST METHODS FOR VULANIZED RUBBER AND THERMOPLASTIC ELASTOMERS- TENSION METHOD A. UNDER EVALUATION THE TENSILE AND ELONGATION PROPERTIES OF THE LINER SHALL NOT BE LESS THAN 75 OF THEIR INITIAL VALUES. WARRANTY ATI WARRANTIES BOTH THE HOSE AND COUPLINGS TO BE FREE FROM DEFECTS IN MATERIAL AND WORKMANSHIP FOR A PERIOD OF 10 YEARS. UPON EVALUATION HOSE FOUND TO BE DEFECTIVE WILL BE REPAIRED OR REPLACED BY ATI AT NO CHARGE TO THE FIRE DEPARTMENT. CENTER /CENTER
US Dollars
