ARMORED TEXTILES N54ARMRE150N ARMORED REEL SINGLE JACKET FIRE HOSE 1"" X 150 FT 300 PSI RED ARMORED REEL IS A ONE-INCH POLYESTER JACKETED LIGHTWEIGHT SEMI-RIGID HOSE INTENDED TO REPLACE THE HEAVY RUBBER HOSE TRADITIONALLY USED AS A BOOSTER LINE. LIKE THAT BOOSTER LINE ARMORED REEL CAN BE CHARGED WHILE ON THE REEL. IT MEETS OR EXCEEDS NFPA 1961 FIRE HOSE STANDARD 2013 EDITION. JACKET CONSTRUCTION THE HOSE IS SINGLE JACKET CONSTRUCTED WITH 100 CONTINUOUS VIRGIN HIGH TENACITY POLYESTER THAT IS CIRCULAR WOVEN. THE OUTER JACKET IS THOROUGHLY IMPREGNATED WITH A POLYMER COMPOUND TO SEAL THE JACKET AND PROVIDE SUPERIOR RESISTANCE TO CHEMICALS ABRASION OIL AND ULTRA-VIOLET LIGHT. COMPOUND IS HEAT SET AT 250° F. LINING THE SYNTHETIC LINING IS 0.023"" EXTRUDED POLYURETHANE COMBINED WITH A HELICAL INTERIOR REINFORCEMENT. THE LINING IS FLEXIBLE BETWEEN-58° F AND 180°F AND COMPOUNDED TO RESIST DETERIORATION FROM OZONE. NO RECLAIMED MATERIAL IS USED. THE FINISHED FORM SHALL BE FREE OF PITS OR OTHER IMPERFECTIONS RESULTING IN A SMOOTH LINING THAT REDUCES FRICTION LOSS. ADHESION THE RATE OF SEPARATION BETWEEN THE LINER AND INSIDE JACKET IS SUCH THAT 1.5"" WIDE STRIP CUT TRANSVERSELY SHALL NOT BE GREATER THAN 1"" PER MINUTE OVER A PERIOD OF TEN MINUTES UNDER A WEIGHT OF 12 POUNDS . ABRASION RESISTANCE OUTER JACKET MUST WITHSTAND A MINIMUM OF 15000 CYCLES ON THE TABER ABRASER WITH NO ABRASION THROUGH THE FILLER YARN AS DEFINED IN FM CLASS NUMBER 2111 FACTORY MUTUAL APPROVAL STANDARD FOR FIRE HOSE. COLD RESISTANCE HOSE SHALL HAVE THE CAPABILITY OF USE DOWN TO-40 ° F. THERE SHALL BE NO APPARENT DAMAGE TO JACKET OR LINING WHEN SUBJECTED TO THE FOLLOWING COLD BEND TEST A 3-FOOT SECTION OF HOSE SHALL BE EXPOSED TO A TEMPERATURE OF-40 ° F. FOR A PERIOD OF 24 HOURS. AT THE END OF THE EXPOSURE PERIOD THE HOSE SHALL BE RAPIDLY BENT 180 DEGREES BACK ONTO ITSELF FIRST ONE WAY AND THEN THE OTHER. FOLLOWING THIS PROCEDURE THE HOSE SHALL NOT LEAK NOR SHOW
US Dollars
